Thx for the advice guys.
When setting up the sump, I changed plans
LH chamber => Inlet & heater (only reason heater would burn out in last chamber of sump is if inlet and overflow were both blocked)
Middle chamber => ceramic rings
RH chamber => return pump + protein skimmer (had to angle the skimmer, as too tall)
Skimmer is 'berlin air lift 90g' with a 2x300l/h air pump (both linked to skimmer) but not sure if I have set the valve on air pump to the best flow yet, as don't know the best 'foaminess'.
On Saturday I mixed the salt in the tank (@ 25'C to 1.023SG) and then rinsed / added the coral sand (using a bowl). Since then the water has been cloudy, but not sure if its just cos never rinsed the sand enough or what.
There doesn't seem to be much filter going on, is there something I can add to the sump?
Thx
When setting up the sump, I changed plans
LH chamber => Inlet & heater (only reason heater would burn out in last chamber of sump is if inlet and overflow were both blocked)
Middle chamber => ceramic rings
RH chamber => return pump + protein skimmer (had to angle the skimmer, as too tall)
Skimmer is 'berlin air lift 90g' with a 2x300l/h air pump (both linked to skimmer) but not sure if I have set the valve on air pump to the best flow yet, as don't know the best 'foaminess'.
On Saturday I mixed the salt in the tank (@ 25'C to 1.023SG) and then rinsed / added the coral sand (using a bowl). Since then the water has been cloudy, but not sure if its just cos never rinsed the sand enough or what.
There doesn't seem to be much filter going on, is there something I can add to the sump?
Thx