Tank Dividers

[ryan422]

Hi, new to this site, I have looked everywhere possible, for a tank divider for my odd shaped tank,

My tank is a Fluval 800

it is 17 inches by 14 inches.

Does anyone know any websites which sell a tank divider big enough?

I was going to make one but i cant find pre-holled plastic, and it would take me forever to drill 1000 odd holes (so the heat can get through the both sides of the tanks.

please post ure websites of where i could get a big enough tank divider (does not matter if it is too big i can cut it down)

or any bright sparks out there who knoe what shop i can buy pre-holled plastic (holes have to be ever so small, i breed live bearers, molly, guppys, plattys ect)

I live in the U.K in England, Surrey

Thankyou
Ryan422
bordercollies704@tiscali.co.uk

 

[emma12321]

Hi Ryan, Welcome to the forum

Why not go to a craft shop and get some plastic mesh/canvas that is used for x stitching, then get some of the plastic edge strips from a stationary shop that are used to hold paperwork together and slot them on to the edge of the canvas this will make it more sturdy. the canvas comes in different hole sizes.

Hope this helps

Emma

 

[Rooster]

Hi Ryan, Welcome to the forum

Why not go to a craft shop and get some plastic mesh/canvas that is used for x stitching, then get some of the plastic edge strips from a stationary shop that are used to hold paperwork together and slot them on to the edge of the canvas this will make it more sturdy. the canvas comes in different hole sizes.

Hope this helps

Emma

What a cracking idea The edging stuff is also sold as poster top/bottom - longer lengths !
This is on my shopping list.... off to Hobbycraft !