Should I Add Tap Safe If My Clourines O.8

[sibbick92]

can anyone tell if i should add tap safe how much if my readins 0.8 ish on clourine scale test ny tanks 90 litres and the tap safe says add one inner cap to 45 litres of water cheeeeeeeeeeeeeeeeeeeeeeeeeeeers

 

[sibbick92]

can anyone tell if i should add tap safe how much if my readins 0.8 ish on clourine scale test ny tanks 90 litres and the tap safe says add one inner cap to 45 litres of water cheeeeeeeeeeeeeeeeeeeeeeeeeeeers

is no one going to help whats the point in this forum ill just change to another one that helps if noone replys to anyof my messages

 

[lostlogik]

Well I suppose it might help if you asked a slightly more specific question. But I accept there hasn't been any reply to your question.

To answer, I'd always add tap safe or similar to water that's come straight from a tap before putting it in my aquarium. How much to dose? Well that's just a simple case of mathematics. Work out how much water you're changing and apply an appropriate ratio to the 1 cap: 45 litres as instructed.

 

[sibbick92]

Well I suppose it might help if you asked a slightly more specific question. But I accept there hasn't been any reply to your question.

To answer, I'd always add tap safe or similar to water that's come straight from a tap before putting it in my aquarium. How much to dose? Well that's just a simple case of mathematics. Work out how much water you're changing and apply an appropriate ratio to the 1 cap: 45 litres as instructed.

ahhh no i just meant if i should at it into the tank because i added it to the water before i put it in but still gettng bit of low readding on it

 

[lostlogik]

ahhh no i just meant if i should at it into the tank because i added it to the water before i put it in but still gettng bit of low readding on it

well, if I had any chlorine in my tank I'd worry and yes, I'd put Stress Coatv(or similar) straight in the tank. 0.8ppm seems high and I'm surprised you've not lost fish yet. Most municipal supplies are in range 0.5 - 3ppm (I think, don't quote me).

You sure about your test result?

 

[sibbick92]

ahhh no i just meant if i should at it into the tank because i added it to the water before i put it in but still gettng bit of low readding on it

well, if I had any chlorine in my tank I'd worry and yes, I'd put Stress Coatv(or similar) straight in the tank. 0.8ppm seems high and I'm surprised you've not lost fish yet. Most municipal supplies are in range 0.5 - 3ppm (I think, don't quote me).

You sure about your test result?

ill check again two mins mate

i addded stress zyme yesterday is that any good

 

[ZoddyZod]

Why are you testing for chlorine? Who advised you that this was needed?

All tap water contains chlorine, there's not reason to test to see what level it is.

A dechlorinator is all that is required to ensure your fish and bacteria colony are not affected by chlorine.

 

[ZoddyZod]

why haven't you replied? What's the point of being a member if you don't answer? Think we'll just have to get anotehr member instead.

 

[sibbick92]

why haven't you replied? What's the point of being a member if you don't answer? Think we'll just have to get anotehr member instead.

yeah i like to check eveything even ph lol

and i was replying but on my phone carnt really see much lol but on laptop now lol

 

[mike455555]

why haven't you replied? What's the point of being a member if you don't answer? Think we'll just have to get anotehr member instead.

that made me laugh ... you should add tap safe or leave the water to stand so the chlorine go's out or it will hurt your bacteria

 

[sibbick92]

I always add tap safe but my question was can I add more into my tank as I got a reading of it lol

Ive done it yesterday anyway so dont matter my fish are looking good lol

Anyone no where I can get cornet snails from I need sum lol