Hi Guys,
I'm starting up my planted tank again after a couple of years. Dug all my equiptment out of the garage and was doing a stock check and have found that my powerhead has died, I'm looking for advice on which flow rate I should go for ideally to replace it.
My current set-up is a 180 litre bowfront tank, which is densly populated with slower growing plants, anubius, java fern etc. Got a few valis, which are just there to add to biomass. Also DIYing CO2 with around 2WPG.
I'm not too well read up on flowrate, so I was hoping someone could explain what I should be aiming for (and even better an why!). I'm also looking at adding some HC in the near future, so not sure if that changes things with its small root system.
Cheers,
Tom
I'm starting up my planted tank again after a couple of years. Dug all my equiptment out of the garage and was doing a stock check and have found that my powerhead has died, I'm looking for advice on which flow rate I should go for ideally to replace it.
My current set-up is a 180 litre bowfront tank, which is densly populated with slower growing plants, anubius, java fern etc. Got a few valis, which are just there to add to biomass. Also DIYing CO2 with around 2WPG.
I'm not too well read up on flowrate, so I was hoping someone could explain what I should be aiming for (and even better an why!). I'm also looking at adding some HC in the near future, so not sure if that changes things with its small root system.
Cheers,
Tom