LinasFishLife
New Member
Hello, everyone. This will be my first time keeping fish. I’m planning on keeping African dwarf frogs in this tank and later adding a betta. Maybe a snail. Any of them I am prepared to separate in case they do not get along.
I’m trying to figure out a few things about the cycling process. Before I ask my questions, here is some information on my set up: I have a 10 gallon tank. I’m using sand substrate that I’ve rinsed. I currently have two medium sized decorations and mini terracotta pots but will later be adding smooth rocks and real plants after the cycling process (I did some research on this and I just thought it less complicated for me during testing). For the filter I’ve replaced the cartridge with a coarse sponge. I’ve purchased the API tap water conditioner and the API Freshwater Master Test Kit. Tomorrow I’m getting their Quick Start bottle in the mail since supposedly it would help speed up the cycling process.
I’m wondering if I can use the Hikari freeze-dried bloodworms for cycling. I also have a small container of newt and aquatic frog food that was kind of expensive so for that reason I’d rather not use that for cycling. I’ve read that this process can take anywhere between 2 weeks-2 months, so I’m thinking I would end up using that whole container, if not most of it. Would I be adding food everyday during cycling? And if I’m using freeze-dried bloodworms, how many should I add? Should I ever take any of the old bloodworms out?
So these are the steps for fishless cycling as I understand it:
Are any further tests needed after this? I plan on doing a 25% water change once a week, including using a syphon. Should I then test again or sometime before?
This was a lot of questions, sorry. I just want to make sure I’m doing everything correctly.
I’m trying to figure out a few things about the cycling process. Before I ask my questions, here is some information on my set up: I have a 10 gallon tank. I’m using sand substrate that I’ve rinsed. I currently have two medium sized decorations and mini terracotta pots but will later be adding smooth rocks and real plants after the cycling process (I did some research on this and I just thought it less complicated for me during testing). For the filter I’ve replaced the cartridge with a coarse sponge. I’ve purchased the API tap water conditioner and the API Freshwater Master Test Kit. Tomorrow I’m getting their Quick Start bottle in the mail since supposedly it would help speed up the cycling process.
I’m wondering if I can use the Hikari freeze-dried bloodworms for cycling. I also have a small container of newt and aquatic frog food that was kind of expensive so for that reason I’d rather not use that for cycling. I’ve read that this process can take anywhere between 2 weeks-2 months, so I’m thinking I would end up using that whole container, if not most of it. Would I be adding food everyday during cycling? And if I’m using freeze-dried bloodworms, how many should I add? Should I ever take any of the old bloodworms out?
So these are the steps for fishless cycling as I understand it:
- Rinse off the tank, gravel, and decorations. Do not use soap. Set up the tank.
- Fill tank with tap water and add conditioner.
- Run the filter and heater until water is 78 degrees.
- Add fish food (I’ll be adding the Quick Start tomorrow).
- Test every other day until ammonia and nitrite are 0, and nitrate is 5ppm or 10ppm (I’m going with betta instructions here. I wasn’t able to find nitrate for African dwarf frogs other than it should be below 20). PH should be between 6.8 and 7.2 on chart.
- Add more fish food (and Quick Start?). Repeat last step until ammonia and nitrate drop to 0 in a 24 hour period. I would repeat this step once more just to make sure.
- Once everything reads correctly, turn off the filter and do a 80% water change. Fill a bucket with tap water and add water conditioner (How long do I have to wait before adding the water to the tank, especially for when I have fish in there?). Make sure water is close to 78 degrees before adding to the tank.
- Turn filter back on.
Are any further tests needed after this? I plan on doing a 25% water change once a week, including using a syphon. Should I then test again or sometime before?
This was a lot of questions, sorry. I just want to make sure I’m doing everything correctly.