MermaidMel
Official Forum Weirdo Detective
- Joined
- Jul 14, 2007
- Messages
- 3,972
- Reaction score
- 0
I want to put the pipes from my Tetratec Ex into the lid of my Trigon 190
The tubes go into hard plastic square U shaped pieces
If I make a neat hole about an inch away from the edge of the lid, it will hold the U shaped pieces nicely in place
So the question is how to make a hole that isn't along an edge - that would be easy, I could use a pen knife
If I drill plastic, would it snap?
If I burn a neat hole, what would I use to burn it?
Suggestions please wise people x
The tubes go into hard plastic square U shaped pieces
If I make a neat hole about an inch away from the edge of the lid, it will hold the U shaped pieces nicely in place
So the question is how to make a hole that isn't along an edge - that would be easy, I could use a pen knife
If I drill plastic, would it snap?
If I burn a neat hole, what would I use to burn it?
Suggestions please wise people x