Surface Agitation/water Movement

[oswoldy]

What do you think???

Mike

 

[tenohfive]

Loads of surface agitation. On most of my tanks I just get a slight rippling effect, so you've got more than enough there.

 

[Loops]

I'd say that was plenty ... just needs to break the surface doesn't it

 

[oswoldy]

Loads of surface agitation. On most of my tanks I just get a slight rippling effect, so you've got more than enough there.

The water doesnt ripple around the edges of the tank just where it leaves the spraybar, but I assume by the above comment that thats ok?

Also do you think it would create enough water movement around the tank?

Mike

 

[minxfishy]

Loads, I keep my spray bars, below the water surface so it doesnt sound like niagra falls in my lounge

 

[weejen]

yes i would deffo say thats enough. my filter outlets are just below the surface. cause when they are above makes me wanna pee all the time lol

 

[oswoldy]

Im quite lucky then because that makes no noise at all with the lid shut. I assume the current produced should suffice then.

Mike

 

[tenohfive]

If its the tank thats listed in your sig, then yes.

 

[england]

yep look's good mike

 

[oswoldy]

If its the tank thats listed in your sig, then yes.

Tis indeed!

Thats ok then, as im looking to remove the Fluval 3+ once the Eheim is mature. I plan on putting the Fluval media inside the Eheim to keep it mature so if one breaks I can swap then over instantly.

Mike