Yohance1130
Fish Fanatic
3 days ago I purchased 4 new panda Corydoras from my Lfs to add to my aquarium I did not quarantine them since the heater in my quarantine tank stopped working and there was only 1 harlequin rasbora due to some recently dying I will be getting more soon inside of my 20 gallon aquarium and I also did not mind treating the main tank if needed in case of emergency.
All 4 of the Cories when I got them had ragged fins and slight cuts in their fins and also they were flashing on the substrate often. I have completed two 50% water changes one yesterday and the day I got them.
Currently (today) their fins are showing signs of new growth and are healing nicely the Cories are still moving around like normal healthy Corries but with the occasional flash.
(today) the frequency of the flashing has still not decreased and is still the same frequency from the day I got them
Also 1 of the Harlequin Rasboras in the aquarium started flashing as will on the first day I got the Cories but since then has stopped and I have never seen him flash again after I completed the two water changes
What should I do?
The tank is fully cycled and has been cycled for 4 months now
I will provide the test results of my parameters later since I am a little bit busy at the moment.
All 4 of the Cories when I got them had ragged fins and slight cuts in their fins and also they were flashing on the substrate often. I have completed two 50% water changes one yesterday and the day I got them.
Currently (today) their fins are showing signs of new growth and are healing nicely the Cories are still moving around like normal healthy Corries but with the occasional flash.
(today) the frequency of the flashing has still not decreased and is still the same frequency from the day I got them
Also 1 of the Harlequin Rasboras in the aquarium started flashing as will on the first day I got the Cories but since then has stopped and I have never seen him flash again after I completed the two water changes
What should I do?
The tank is fully cycled and has been cycled for 4 months now
I will provide the test results of my parameters later since I am a little bit busy at the moment.