Build an aquarium stand?

Anyone here build aquarium stands?.
I need to make one for a 20long... Just need to figure out all the cuts i need. I don't have a saw so I would like to have them cut it at home Depot...

The King of DIY has some really good videos on making stands from 2x4. I would check him out on youtube.

I have built a few. The design here https://www.pinterest.ca/pin/368873025720831750/, might be a good start but if it was mine I would also sheet in with light plywood the back and sides, the top will also need a heavy flat piece of plywood or something similar. Sheeting in the back ensures the stand stays straight even if the fasteners at the corners are not done well.

A stand should at the least be the following:
1. Simple (no fancy cuts) (for your stand)
2. Solid (Weight transferred from the tank to the floor via vertical wooden pieces) ie you are not depending on the fasteners to support the weight of the tank.
3. Solid support for the underside of the tank
4. Continuous contact on the floor, less likelyhood of denting or damaging the floor. ie no small points of contact with the floor. A 20 gallon tank and stand with all accessories might weight 300 lbs. Small 1" area feet will end up with 75 lbs of force on each foot.

When you build the stand ensure you do most of the work on an honestly flat surface makes

20 long is a nice size tank. It won't be too heavy so the design I showed you might be overkill.

There it is..

I actually sanded it and stained.. here's the final product... Got the C2 today and actually put water in ....

Nice work. I always plan to sand and stain, but I'm always building racks right after moves and have to get the fish in fast.