I just purchased a used 56 gallon aquarium (30 wide x 18 deep x 24 tall in inches) and stand. I plan on dividing it into three sections, using black plexiglass drilled for water flow.
This setup would be for my three (3) male Bettas and am trying to decide on my filter options. I have always used HOB filters and was thinking of using two (2)Emperor 280 filters, one on each end with baffles to filter the tank with a 250 watt heater (Visi-Therm Stealth Heater) in the middle section.
I originally wanted to block off the rear about six (6) inches in, use a single filter (Emperor 400) and heater in this section, then divide the front section into three (3), however; due to the tank frame and center support, I don't think I will be able to get the plexi in.
Looking for some ideas from the experienced crowd......
Thanks
Gordi
This setup would be for my three (3) male Bettas and am trying to decide on my filter options. I have always used HOB filters and was thinking of using two (2)Emperor 280 filters, one on each end with baffles to filter the tank with a 250 watt heater (Visi-Therm Stealth Heater) in the middle section.
I originally wanted to block off the rear about six (6) inches in, use a single filter (Emperor 400) and heater in this section, then divide the front section into three (3), however; due to the tank frame and center support, I don't think I will be able to get the plexi in.
Looking for some ideas from the experienced crowd......
Thanks
Gordi
