i've been thinking about changing to sand for a while now.
it would be a massive task to swap the gravel for sand
one of my concerns is how to clean the sand though. At the moment i can vacuum my gravel and the 'rubbish' flows up the tube and the gravel hovers near the bottom of the spout then falls back into the tank again. Id be worried that the sand would get sucked up
its a doddle.
wash the sand in a small bucket with your hand, about 5-6 times so the water in the bucket looks clear, then put the sand in a big bucket...repeat until u have enough sand.
drain 1/2 the tank into another new (i.e. no chemicals have been used in it) big plastic tub
scoop the fish out into the tub
scoop out the gravel from aquarium
chuck the sand into the tank. if its washed proper, will only take 10-20mins to be clear
make sure the filter intake is not resting near the sand though, as sand sucked up could cause problems with impeller.
chuck fish back into tank
should be an hours job.
yes sand gets sucked up by the gravel vac, but not as much as you would think. typically i hold it 5mm above the sand.
and the sand end up in the bucket..so once you drain the water n poop out...u can get the sand and put it back in the tank if you want.