Bazza57
Fish Fanatic
Has anyone on this forum used 6mm beer pump piping with their tanks? You know, the sort that beer gets pumped from the cellar. 
Basically, this stuff is very tough & will not collapse, but I can't figure out how to make 180 degree turns - are there any compatable flexible or elbow joints around.
This stuff slips inside of the fluval elbows - I am trying to feed this stuff from the outlet (Via an adapter) of a Fluval 1 to feed two home made overhead trickle/drip tray units.
Failing any success with this, how the hell can I feed the trickle trays from my old fluval 1.
This project is not critical, but a little experiment which I am prone to playing around with at the moment -Ideas anyone?
Basically, this stuff is very tough & will not collapse, but I can't figure out how to make 180 degree turns - are there any compatable flexible or elbow joints around.
This stuff slips inside of the fluval elbows - I am trying to feed this stuff from the outlet (Via an adapter) of a Fluval 1 to feed two home made overhead trickle/drip tray units.
Failing any success with this, how the hell can I feed the trickle trays from my old fluval 1.
This project is not critical, but a little experiment which I am prone to playing around with at the moment -Ideas anyone?
